Home/Amplifier /Stereo Amplifier T A Power Plant Balanced
Advertise

Photos and specs Stereo amplifier T A Power Plant Balanced

Review and test Stereo amplifier T A Power Plant Balanced
  • Stereo Amplifier T A Power Plant Balanced
  • Stereo Amplifier T A Power Plant Balanced
  • Stereo Amplifier T A Power Plant Balanced
  • Stereo Amplifier T A Power Plant Balanced
  • Stereo Amplifier T A Power Plant Balanced

Description stereo amplifier, T A Power Plant Balanced



Integrated stereo amplifier Power Plant Balanced is part of a series E components T A, characterized by the use of the most modern components combined with traditional circuitry. In particular, the preamplifier uses the latest OS, developed for use in audiodemo, c a separate stable power supply, which allowed seriously to improve the sound quality.


To T A Power Plant Balanced scheme applied to a two-stage volume control a variable resistor Alps, it is possible to disable the adjustments of timbre and loudness, to reduce transmission of the audio signal, and obtaining a linear frequency response. As the name suggests the model, the amplifier has unbalanced and balanced inputs, the circuit is fully symmetric and there are no preamp coupling capacitors. The use of XLR and RCA inputs are very flexible, and they can be assigned to different signal sources.


To switch inputs applied high quality relay with gold plated contacts located near the connector block. Output stages of the amplifier they are pulsed (PWM - pulse width modulation), and are made of discrete elements (in particular, high-speed MOSFET transistors) directly on the plant firm. They are covered by shallow negative feedback for stabilization irrespective of changes of load characteristics, and other external factors. The amplifier is able to output up to 50 Amps, and confidently works with any acoustics.


Power pack T A Power Plant Balanced fully analog, made on the basis of the toroidal transformer, and has a buffer circuit for each amplifier stage. This solution allowed us to significantly expand the dynamic range of sound and reduced noise.


Amplifier T A Power Plant Balanced has five inputs two of which can be switched to balanced or unbalanced mode. Instead of one of the line inputs, you can set the cost of the Phono stage PHE MM or PHE MC. Provides input/output to connect a recording device, the output of the preamp system with built-in RS232 and branded "the bus" E-Link and the front panel has a output for headphones.


Features stereo amplifier, T A Power Plant Balanced


Balanced design, XLR inputs
Switchable tone controls and loudness
Headphone output


Characteristics of the stereo amplifier T A Power Plant Balanced

Output power 2х140 watts (8 Ohms), 2 × 250 W (4 ohms)
Inputs 5 RCA, 2 XLR
OutputsPreAmp, headphones, record
Frequency range1 Hz – 60 kHz ( /- 3dB)
Distortionless than 0.005%
Dimensions 120 x 440 x 390 mm
Weight 13 kg

Advertise
Copyright © 2013-2024 audio-reviews.com